The device may already be in use or may be defective. Smart Card Resource Manager received unexpected exception from PnP event %1Īn attempt to add a Plug and Play reader failed. Smart Card Resource Manager failed to register service: %1 Resource Manager cannot create shutdown event flag: %1 Initialization of Service Status Critical Section failed The smart card reader will not be recognized by the service until it's removed from the computer and reinserted or until the computer is restarted. Reader shutdown exception from eject smart card commandĪ smart card reader could not eject a smart card while the smart card reader was shutting down.Ī smart card reader did not properly respond to a request for information about the device, which is required for constructing the smart card reader name. %1 = Name of the smart card reader that is duplicatedįailed to create global reader change event. ![]() Remove the smart card reader that is causing this error message. There are two smart card readers that have the same name. Server Control failed to create shutdown event: %1 Restarting the computer may resolve the issue. The most common cause is limited computer resources. This is an internal, unrecoverable error that indicates a failure in the smart card service. Server Control has no memory for reader reference object. %1 = Number of seconds the IOCTL has been waitingĪn error occurred, and the service cannot initialize properly. This can leave the smart card reader in an unusable state until it's removed from the computer or the computer is restarted. Currently, this error is sent after a reader doesn't respond for 150 seconds. This occurs when a reader hasn't responded to an IOCTL after an unusually long period of time. ![]() If this error persists, your smart card or reader may not be functioning correctly. Smart Card Reader '%2' hasn't responded to IOCTL %3 in %1 seconds. %4 = First 4 bytes of the command that was sent to the smart card This occurs if the resource manager attempts to cancel a command to the smart card reader when the smart card service is shutting down or after a smart card is removed from the smart card reader and the command could not be canceled. Smart Card Resource Manager was unable to cancel IOCTL %3 for reader '%2': %1. Note IOCTL in the following table refers to input and output control.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |